Mitsubishi MELSEC-Q Series User Manual page 199

5
SETTINGS AND PROCEDURES BEFORE OPERATION
(3) When configuring a CC-Link system
Development environment (PC)
Start up the C Controller module.
Set parameters, referring to (2) for a single CPU system,
or the flowchart in Section 17.1 for a multiple CPU system.
1)
Start up CC-Link utility to set Connection settings, and
connect
computer) to the C Controller module.
On the Module information screen, verify the list of CC-
Link modules controlled by the C Controller module.
In the Parameter settings of the CC-Link utility, set the
CC-Link module parameters.
No
Set the logical station No. on the <<Target settings>> tab
of the CC-Link utility.
Write the set parameters from the <<Online operation>>
tab of the CC-Link utility to the C Controller module.
Reset the C Controller module with the RESET/SELECT
switch. (Resetting the module makes the written
parameters effective.)
Figure 5.11 CC-Link system configuration
Procedures for operation
the development environment
Is the access target system
a multiple CPU system?
Yes
Is it a single CPU system?
Yes
(To 2) on next page)
* 1 To write the parameters, connect the utility to the C Controller module with the write authority.
( Section 5.11, Section 9.1.3)
Figure 5.12 Flowchart for CC-Link system configuration
5.3 Settings and Procedures before Operation
C Controller module
Ethernet
This section (1)
This section (2) or Section 17.1
This section (2) or Section 16.1
Section 9.1.3
(personal
Section 9.3.2
Section 9.3.5
Section 9.3.6
No
(To 3) on next page)
Section 9.3.4
*1
Section 5.4 (3)
1
2
CC-Link
3
4
5
6
7
8
5
- 13