Mitsubishi MELSEC-Q Series User Manual page 302

9
UTILITY OPERATION
Remark
(2) Utilizing existing parameter setting of the parameter setting file
Remark
9
- 11 9.1 Common Utility Operations
9.1.6 Parameter setting file
1. The name of the currently used parameter setting file is displayed on the
status bar of the utilities other than the Device monitoring utility. C Controller
setting utility, CC-Link utility, or MELSECNET/H utility.
2. The following indicates the extensions for parameter setting files.
Utility name
C Controller setting utility
CC-Link utility
MELSECNET/H utility
CC IE Control utility
3. The standard directory, where the utilities other than the Device monitoring
utility save parameter setting files, is "C:\MELSEC\CCPU\Param". (When
SW PVC-CCPU is installed in "C:\MELSEC")
4. Double-clicking any saved parameter setting file (*.cst/*.ccl/*.mnh/*.mng)
starts the corresponding utility with the saved parameter settings loaded.
By loading a parameter setting file into multiple development environments (personal
computers), multiple modules can be used under the same parameter setting.
Existing parameter settings can be utilized without use of any parameter setting
file.
Its procedure is described below.
1. Set the parameters in a utility other than the Device monitoring utility.
2. Open the "Connection settings" screen, and connect to the module where the
parameters are to be written.
3. On the <<Online operation>> tab of the utility, click the
the parameters to the C Controller module.
4. By repeating Steps 2 and 3, the same parameter setting can be set to multiple
modules.
Table9.6 Extensions of parameter setting files
Parameter setting file extension
cst
ccl
mnh
mng
button to write
Write