Mitsubishi MELSEC-Q Series User Manual page 706

18
TROUBLESHOOTING
(3) Detailed error descriptions and corrective actions by error codes
Error code
1009
1300
1310
1401
1403
1412
1413
* 1 The error information (module No.) stored in "Event information" on the <<Event history>> tab of the C Controller setting utility is
displayed as given below.
"Error information: XX - YYY"
XX (DEC.): Slot No. (0 to 63), CPU No. (1 to 4)
YYY (HEX.): Start I/O No.
18
18.3 Actions for Lit/Flashing ERR. LED
- 25
The following provides the detailed error descriptions and corrective actions that can
be identified from each error code
For an error code not referred to the error code table, please consult your local
Mitsubishi service center or representative, explaining the details of the problem.
(a) Error code list (1000 to 1999).
Table18.3 Error codes
Error message
MAIN CPU DOWN
FUSE BREAK OFF
I/O INT.ERROR
SP.UNIT DOWN
SP.UNIT DOWN
CONTROL-BUS.ERR.
CONTROL-BUS.ERR.
16 (000 to 0FF, 3E0 to 3E3)
LED status
Error information
RUN
Off
*1
Off/On
Module No.
Off
*1
Off/On
Module No.
*1
Off/On
Module No.
*1
Off
Module No.
Off
CPU operation status
ERR.
Flashing Stop
*2
Flashing/On
Stop/Continue
Flashing Stop
*3
Flashing/On
Stop/Continue
*3
Flashing/On
Stop/Continue
Flashing Stop
Flashing Stop