Mitsubishi MELSEC-Q Series User Manual page 763

18
TROUBLESHOOTING
Index
L station to M station setting in the LX/LY setting 1 is
overlapping.
Correct these settings.
L station to M station setting in the LX/LY setting 2 is
overlapping.
Correct these settings.
LB setting 1 is overlapping.
Correct these settings.
LB setting 2 is overlapping.
Correct these settings.
Link device refresh cycle is out of range.
Set it to 0 or within the range of 10 to 1000.
Link side end device No. is out of range.
Set it within the range of XX to YY.
[L]
Link side number of points is out of range.
Set it within the range of XX to YY.
Link side start device No. is out of range.
Set it within the range of XX to YY.
Logging screen cannot be displayed correctly. Return to
diagnostics screen.
Logical station No. is out of range.
Set it within the range of 65 to 239.
LW setting 1 is overlapping.
Correct these settings.
LW setting 2 is overlapping.
Correct these settings.
M station to L station setting in the LX/LY setting 1 is
overlapping.
Correct these settings.
M station to L station setting in the LX/LY setting 2 is
overlapping.
Correct these settings.
Master station 1 has not been set.
[M]
Set the master station.
Master station 2 has not been set.
Set the master station.
Maximum number of transients per station is out of range.
Set it within the range of 1 to 10.
Monitoring time setting is out of range.
Set it within the range of 5 to 2000.
Network No. has not been entered.
Network No. is out of range.
Set it within the range of 1 to 239.
Network No. of the connected station is invalid.
[N]
Network No. XX is overlapping.
Correct these settings.
Network parameters are not set correctly.
Correct the settings then retry the diagnostics.
Table18.24 Error messages on CC IE Control utility (Continued)
Error message Corrective action
Eliminate overlap in "M station to L station" settings in LX/LY
setting 1.
Eliminate overlap in "M station to L station" settings in LX/LY
setting 2.
Eliminate overlap in LB setting 1.
Eliminate overlap in LB setting 2.
Set the link device refresh cycle to 0 or within the range of 10 to
1000.
Set a link side end device No. within the range of XX to YY.
Set a link side number of points within the range of XX to YY.
Set a link side start device No. within the range of XX to YY.
Correct the network parameters.
Restart the CC IE Control utility.
Since installation of SW PVC-CCPU may have failed, reinstall
it.
Set a logical station No. within the range of 65 to 239.
Eliminate overlap in LW setting 1.
Eliminate overlap in LW setting 2.
Eliminate overlap in "L station to M station" settings in LX/LY
setting 1.
Eliminate overlap in "L station to M station" settings in LX/LY
setting 2.
Set I/O master station 1.
Set I/O master station 2.
Set a value for "Maximum number of transients per station"
within the range of 1 to 10.
Set a monitoring time within the range of 5 to 2000.
Specify a network No. within the range of 1 to 239.
Set a network No. within the range of 1 to 239.
Correct the network No.
Eliminate the overlap of the network No. setting.
Correct the network parameters.
18.4 Error Code and Error Message Lists
18.4.3 Actions by error messages
17
18
(To next page)
18
- 82