Mitsubishi MELSEC-Q Series User Manual page 415

9
UTILITY OPERATION
Table9.82 Explanation of Routing parameter settings screen (Continued)
Item
Max. size of transient
transmission via other network
No.
Channel No.51 to Channel
No.54
button
Clear
button
Check
button
End
button
Cancel
For each channel No., set the maximum transmission size of data sent by transient
transmission from a user program via another network (No.).
For each channel No., set the maximum transmission size for the case where data are
sent by transient transmission to another network (No.) via a MELSECNET/H module.
(Initial value: 480 words, Setting range: 960 words, 480 words)
Clears the " Transfer target network No., "Relay network No.", and "Relay station No."
settings.
Checks the " Transfer target network No., "Relay network No.", and "Relay station No."
settings.
Saves the settings and closes the "Routing parameter settings" screen.
Closes the "Routing parameter settings" screen without saving the settings.
* 1 Select 960 words only when the intermediate and target stations of transient transmission via
another network (No.) are the MELSEC-Q series network modules.
Select 480 words when the intermediate and target stations of transient transmission are other
than the MELSEC-Q series network modules.
In this case, setting 960 words may cut off the data, disabling normal transient transmission.
Description
9.4 MELSECNET/H Utility
9.4.6 Operating Parameter settings screen
9
10
*1
11
12
13
14
15
16
9
- 124