Mitsubishi MELSEC-Q Series User Manual page 364

9
UTILITY OPERATION
Other station monitoring
Module information
Item
Read parameters
button
Read
Write parameters
button
Write
Verify parameters
button
Verify
Remark
9
- 73 9.3 CC-Link Utility
9.3.4 Operating Online operation screen
Table9.51 Explanation of Online operation screen
Online operation
Reads the CC-Link parameters from the C Controller module.
Writes the set CC-Link parameters to the C Controller module.
The written parameters become effective when the C Controller module is powered off
and then on or is reset.
This button can be used only when "Write authority" was set at the time of setting
Connection settings (
This button cannot be used without "Write authority" (
Compares the CC-Link parameters of the C Controller module with those of the CC-Link
utility.
The result is displayed in the message box.
* 1 If parameter writing is needed when "Write authority" is not set, set Connection settings again and
check the "Write authority" box.
1. Reading/writing/verification can be performed only when the C Controller
module is connected online.
2. When parameters are written to the Q06CCPU-V-B with setting the logical
station No. ( Section 9.3.6), the logical station No. cannot be used.
For the Q06CCPU-V, the logical station No. is available.
Parameter settings
Description
Section 9.1.3).
Target settings Test
*1
Section 9.1.3).