Mitsubishi MELSEC-Q Series User Manual page 205

5
SETTINGS AND PROCEDURES BEFORE OPERATION
(6) When making microcomputer connection with GOT
Connect the GOT to CH2 (RS-232 interface) of the C
Controller module by a cable.
Create and debug a user program using Tornado, and
register it to the C Controller module.
POINT
Development environment (PC)
Figure 5.17 Configuration of microcomputer connection with GOT
Procedures for operation
Start up the C Controller module.
Set parameters, referring to (2) for a single CPU
system, or the flowchart in Section 17.1 for a multiple
CPU system.
On the GOT, make various settings and create screen
programs.
Operation
Figure 5.18 Flowchart for microcomputer connection with GOT
Refer to the following manual for the commands that can be used for data
transmission to the GOT in microcomputer connection.
GOT Manual
C Controller module
Ethernet
5.3 Settings and Procedures before Operation
RS-232
GOT
This section (1)
This section (2) or
This section (2) or
Section 17.1
Section 16.1
GOT Manual
GOT Manual
Chapter 10
5
1
2
3
4
5
6
7
8
- 19