Station No. Setting For Melsec Data Link Functions - Mitsubishi MELSEC-Q Series User Manual

10
FUNCTIONS AND PROGRAMMING

10.3.10 Station No. setting for MELSEC data link functions

The following describes how to specify network No. and station No. for a MELSEC data
link function.
(1) Functions other than extended functions
Q series bus interface
CC-Link IE controller network
MELSECNET/H
CC-Link
* 1
Network No.
1(1
Station No., group No. or all stations
1(1
129(81
Upper Lower
240(F0
<Logical station No. setting method>
Set "0" in the upper byte (network No.) and a logical station No. in the lower byte (station No.).
<Setting range of logical station No.>
Set it in the target settings of the MELSECNET/H utility, CC IE Control utility.
65 (41 ) to 239 (EF ): MELSECNET/H communication
H H
65 (41 ) to 239 (EF ): CC-Link IE controller network communication
H H
Figure 10.20 Station No. setting for CC-Link IE controller network module or MELSECNET/H module
* 2
Network No.
0: CC-Link
Station No.
0(0 ) ro 63(3F
H
Upper Lower
* 3 For CC-Link communication, station No.64 cannot be specified.
When the own station No. is 64, the other station cannot be specified. (Access is allowed only to own station.)
Table10.16 Station numbers specified for MELSEC data link functions
Communication
) to 239(EF ): When specifying the other station in the local network or a station in other network
H H
(When making a send request to CC-Link IE controller network, MELSECNET/H or
MELSECNET/10)
) to 64(40 ) : Other stations
H H
) to 160(A0 ): Group No.1 to 32
H H
Group No.1 to 9 (129(81
target CPU is the QnACPU.
) : All stations
H
(Available only when the SEND function (mdSend) is used.)
<Logical station No. setting method>
Set "0" in the upper byte (network No.) and a logical station No. in
the lower byte (station No.).
<The setting range of logical station No.>
) : Other station
H
Set it in the target settings of the CC-Link utility.
65 (41
Figure 10.21 Station No. setting for CC-Link module
10.3 Programming Using MELSEC Data Link Functions
10.3.10 Station No. setting for MELSEC data link functions
Station No. specification
Own station: 255(FF )
H
Other station: 1 (CPU No.1), 2 (CPU No.2), 3 (CPU No.3),
4 (CPU No.4)
Own station: 255(FF )
H
Other station: *1
Own station: 255(FF )
H
Other station: *1
Own station: 255(FF )
H
Other station: 0(0 ) to 63(3F
H
) to 137(89 )) are used in the MELSECNET/10 mode when the
H H
(
Section 9.4.7, 9.5.6)
) to 239 (EF ): CC-Link communication
H H
*2, *3
), 65(41 ) to 239(EF )
H H H
( Section 9.3.6)
10
9
10
11
12
13
14
15
16
- 44