Mitsubishi MELSEC-Q Series User Manual page 699

18
TROUBLESHOOTING
Consult your local Mitsubishi service
center or representative, explaining the
details of the problem.
Figure 18.12 Flowchart for disabling script file execution (for the Q06CCPU-V) (continued)
(2) For the Q06CCPU-V-B
When the user program was started
from a script file in the standard ROM,
perform the following actions.
Activate the default setting mode of the
hardware self-diagnostic function, and
restart the C Controller module.
Activation of the default setting mode
places the C Controller module in the
following status.
Consult your local Mitsubishi service
center or representative, explaining the
details of the problem.
Figure 18.13 Flowchart for disabling script file execution (for the Q06CCPU-V-B)
1
Has the script file
execution stopped?
No
Error occurred
Does the endian
format of the execution file
match the specification of your
C Controller module?
Section 10.2.3 (3)
( Section 10.2.3(3) )
Yes
The IP address returns to the default
IP address.
The script file in the standard ROM
Section 5.10
is deleted. (
Has the script file
execution stopped?
No
18.2.13 When operation is not normal due to script file execution
Yes
Correct the script file in the standard
ROM, or correct the user program
started from the script file in the
standard ROM.
Complete
No
Compile the user program and
regenerate an execution file according
to the C Controller module
specifications.
Completed
)
Yes
Correct the script file in the standard
ROM, or correct the user program
started from the script file in the standard
ROM.
Complete
18.2 Troubleshooting
17
18
18
- 18