Mitsubishi MELSEC-Q Series User Manual page 331

9
UTILITY OPERATION
IP address(*)
Clock(*)
Item
*1, *2
IP address settings
IP address
Subnet mask
Default gateway
*3
button
Set
(a) IP address settings screen
Set the IP address to be used by the C Controller module.
Figure 9.37 IP address screen
Table9.19 Explanation of IP address screen
MD function Option
Displays and sets the IP address used by the C Controller module.
Displays and sets the IP address of the C Controller module.
(Initial value: 192.168.3.3, Setting range:
Displays and sets the subnet mask of the C Controller module.
(Initial value: 255.255.255.0, Setting range: 0.0.0.0 to 255.255.255.255)
Sets the IP address of the default gateway used by the C Controller
module.
(Initial value: None, Setting range:
Writes the "IP address settings" data to the C Controller module.
* 1 When the "IP address" screen is opened, the IP address settings used by the C Controller module
is read and displayed.
When IP address reading is failed, an error message appears and the initial value is displayed in
the each item of "IP address settings".
* 2 The IP address can be set to the initial value by the hardware self-diagnostic function of the C
Controller module.
* 3 The set IP address becomes valid when the C Controller module is powered off and then on or is
reset.
When the IP address of the C Controller module has been changed, set Connection settings with
the new IP address.
1) IP address settings range
The IP addresses available for the C Controller module are indicated below.
Before setting the IP address, consult your network administrator (network
planner or IP address manager).
Class High-order bits of IP address
A
B
C
Description
This section (2)(a)1))
This section (2)(a)1))
Table9.20 IP address settings range
0
10 128.0.0.0 to 191.255.255.255
110 192.0.0.0 to 223.255.255.255
9.2 C Controller Setting Utility
9.2.6 Operating Online operation screen
Reference
section
IP address range
0.0.0.1 to 126.255.255.255
9
- 40
9
10
11
12
13
14
15
16