Mitsubishi MELSEC-Q Series User Manual page 602

12
MULTIPLE CPU SYSTEM CONFIGURATION
(3) Combination of power supply module, base unit and programmable
(4) Precautions for GOT connection
(5) Precautions for MT Developer connection in multiple CPU system
12
- 36 12.3 Precautions for System Configuration
controller CPU
There are restrictions on the combination of the power supply module, base unit and
programmable controller CPU.
( Section 12.1.1)
The display devices applicable to the C Controller module are the same as the ones in
a single CPU system.
( Section 2.4 (5))
The following GOT connection is enabled when the programmable controller CPU is
set as a communication target in a multiple CPU configuration.
Refer to the GOT manual for details.
• Bus connection/direct CPU connection with programmable controller CPU in
multiple CPU configuration
• Connection with module controlled by programmable controller CPU in multiple
CPU configuration
configuration (For Version 00Y or earlier)
When a multiple CPU system includes the C Controller module as CPU No.1 and the
Motion CPU, the MT Developer's (Version 00Y or earlier) communication test cannot
be performed.(A Motion CPU communication test error (error code:12288))will occur.
Perform either of the following for testing the MT Developer's communication.
• Use MT Developer Version 00Z or later.
• When using MT Developer Version 00Y or earlier, CPU No.1 must be a
programmable controller CPU in the multiple CPU system.