NEC PD703114 User Manual page 79

(2) Restriction on conflict between sld instruction and interrupt request
(a) Description
If a conflict occurs between the decode operation of an instruction in <2> immediately before the sld
instruction following an instruction in <1> and an interrupt request before the instruction in <1> is
complete, the execution result of the instruction in <1> may not be stored in a register.
Instruction <1>
• ld instruction:
• sld instruction:
• Multiplication instruction: mul, mulh, mulhi, mulu
Instruction <2>
mov reg1, reg2
satadd reg1, reg2
and reg1, reg2
add reg1, reg2
mulh reg1, reg2
<Example>
<i> ld.w [r11], r10
•
•
•
<ii> mov r10, r28
<iii> sld.w 0x28, r10
(b) Countermeasure
<1> When compiler (CA850) is used
Use CA850 Ver. 2.61 or later because generation of the corresponding instruction sequence can be
automatically suppressed.
<2> For assembler
When executing the sld instruction immediately after instruction <ii>, avoid the above operation
using either of the following methods.
• Insert a nop instruction immediately before the sld instruction.
• Do not use the same register as the sld instruction destination register in the above instruction
<ii> executed immediately before the sld instruction.
CHAPTER 3 CPU FUNCTION
ld.b, ld.h, ld.w, ld.bu, ld.hu
sld.b, sld.h, sld.w, sld.bu, sld.hu
not reg1, reg2
satadd imm5, reg2
tst reg1, reg2
add imm5, reg2
shr imm5, reg2
If the decode operation of the mov instruction <ii> immediately before the sld
instruction <iii> and an interrupt request conflict before execution of the ld
instruction <i> is complete, the execution result of instruction <i> may not be
stored in a register.
User's Manual U15195EJ5V0UD
satsubr reg1, reg2 satsub reg1, reg2
or reg1, reg2 xor reg1, reg2
subr reg1, reg2 sub reg1, reg2
cmp reg1, reg2 cmp imm5, reg2
sar imm5, reg2 shl imm5, reg2
79