Advertisement
Transition Rate
You can set the time taken from the beginning of a
transition to its completion.
The transition rate is configured using the Flexi Pad
control block, utility/shotbox control block and numeric
keypad control block, or the menu.
Note
When a clip transition is selected as the transition type, it
is not possible to set the transition rate.
Transition Rate Input/Display Mode
Transition rate input mode
When entering the transition rate, you can select either
frame number input or timecode input.
For details, see "Timecode input and frame number
input" (page 77).
Frame number input:
Enter a number in the range 0 to 999 frames.
Timecode input:
Enter a value converted to frames of up to 999 frames.
Transition rate display mode
You can set the transition rate display mode to frame
number display or timecode display.
The display mode settings are common to all switcher
banks.
For details, see "Setting the transition rate display"
(page 412).
Frame number display:
Displays the number of frames (0 to 999). Values
entered in timecode input mode are converted to the
number of frames for display.
Timecode display:
Displays a "ss:ff" timecode value (second:frame).
Values entered in frame input mode are converted to
a timecode for display.
Setting the Transition Rate
You can set the speed at which a transition switches from
the current image to a new image (time taken from the
beginning of a transition to its completion).
In an auto transition, the transition is executed
automatically with the preset transition rate.
Setting the transition rate (Flexi Pad
control block)
You can set the transition rate using the Flexi Pad control
block of the target switcher bank.
1
Press the [TRANS RATE] button.
The memory recall section switches to transition rate
operation mode.
2
Enter a transition rate using the number input buttons.
You can switch the input mode using the [TC] button.
In frame number input mode, enter three digits. In
timecode input mode, enter four digits.
The entered value appears in the top right button of
the memory recall section.
To delete the entered value
Press the [CLEAR] button.
3
Press the [ENTER] button.
Setting the transition rate (utility/shotbox
control block and numeric keypad control
block)
When the utility/shotbox control block is switched to
transition rate display mode, the transition rate is
displayed in the memory recall section. Press a memory
recall button to select a transition rate, and set it using the
numeric keypad control block.
Note
You can change the transition rate display mode
transition rate assignments.
For details, see "Setting Transition Rate Display Mode
Buttons" (page 400).
1
Press the [TRANS RATE1] button to [TRANS
RATE3] button in the utility/shotbox control block.
The memory recall section switches to transition rate
display mode.
2
Press the memory recall button displaying the target
transition rate to set, turning it on.
The target region name and transition rate to set are
shown on the display of the numeric keypad control
block.
3
Enter a transition rate using the numeric keypad of the
numeric keypad control block.
You can switch the input mode using the [TC] button.
100
Advertisement
Chapters
