Signal Output Settings (Output Menu); Assigning Output Signals - Sony MVS-6000 User Manual

Signal Output Settings (Output Menu)

For setup relating to signal outputs, use the Switcher >Output menu.
To display the Output menu
In the Engineering Setup menu, select VF3 'Switcher' and HF3 'Output.'
The status area shows the output signal numbers and names for the signals
output from Output 1 to 24.
The following functions are available here.
• Output Assign: Assign the signals output from the Output1 to 24 ports.
• Video Clip: Adjust the clip levels (White Clip, Dark Clip, and Chroma Clip)
• V Blank: Adjust the vertical blanking width for the output signals from each
• Through: Enable or disable through mode. Through mode can be enabled
• Safe Title: Enable or disable safe title, and carry out settings for box 1 and 2
• 4:3 Crop: Set the actual video image to be cropped to a 4:3 aspect ratio when
• FC Adjust: Set the format converter outputs.

Assigning Output Signals

To assign a signal to output from an output port, use the following procedure.
1
2
140

Signal Output Settings (Output Menu)

for the output signals from each of the Output1 to 24 ports.
of the Output1 to 24 ports. The setting is the number of scan lines from the
reference blanking position of field 1 for the particular format which should
be masked.
for AUX1 to 48 outputs, M/E and PGM/PST program outputs, and clean
output.
and cross.
an HD system has a screen aspect ratio of 4:3.
In the Switcher >Output menu, press [Output Assign].
The Output Assign menu appears.
The status area shows the output ports and assigned signals on the left, and
a list of signals that can be assigned on the right.
In the <Output Assign> group, select either of the following.
[Re-Entry Source]: It is possible to make duplicate assignments.
M/E-1 Output 1 to 4
M/E-2 Output 1 to 4
M/E-3 Output 1 to 4
a)
a)
a)