Tally Group Settings; Setting The Tally Group; Wiring Settings; Configuring Wiring - Sony XVS-9000 User Manual

Tally Group Settings

You can select a tally group (1 to 8) to control using S-Bus/
NS-Bus and enable the tally.

Setting the Tally Group

1
Open the Engineering Setup >Router/Tally >Group
Tally menu (7362).
2
In the <Tally Group> group, select the tally group.
Select a group from groups 1 to 4 or groups 5 to 8. To
select more than one group, select groups with
consecutive numbers from among groups 1 to 4 or
groups 5 to 8.
To use both groups 1 to 4 and groups 5 to 8
Press [All Group Enable], turning it on. You can select
groups in both groups 1 to 4 and groups 5 to 8.
3
Enable S-Bus/NS-Bus tally.
Press [SBus Tally Enable] (for S-Bus) or [NSBus Tly
Enable] (for NS-Bus), turning it on.

Wiring Settings

When configuring a system in which the switcher inputs
and outputs connect to a router, configure the connection
information (referred to as "wiring") in the S-Bus/NS-Bus
space.
The settings used are common to both parallel and serial
tallies.

Configuring Wiring

1
In the Engineering Setup >Router/Tally >Wiring
menu (7363), press [New].
The New menu (7363.1) appears.
2
Set the destination.
When configuring more than one wiring setting, you
can specify the destination start and end addresses.
No. Parameter Adjustment
1 Destination
(From)
2 Destination
(To)
3 Destination
(Level)
3
Set the source.
No. Parameter Adjustment
4 Source
(From)
5 Source
(Level)
4
Press [Execute].

Modifying Wiring Settings

1
In the Engineering Setup >Router/Tally >Wiring
menu (7363), press [Modify].
The Modify menu (7363.2) appears.
2
Set the destination and source.
It is not possible to modify the settings for multiple
destinations at the same time.
473
Destination start address
Destination end address
Destination level
Source start address
Source level