Setting Router - Sony CCP-8000 System Setup Manual

3-7. Tally Setup

3-7-1. Setting Router

Engineering Setup → Router/Tally → Router
Page 7361
This menu is used to assign the input and output signals of the switcher on the virtual matrix space of the
S-BUS.
When setting the tallies, the input and output signals to and from the equipment (such as router, switcher
and others) that has the crosspoints should be assigned on the virtual matrix space. When they are as-
signed, serial numbers (unique) are given to all inputs and outputs on the matrix space, of all the equip-
ment that are to be controlled. These serial numbers are necessary for the integrated handling of the
signals.
By assigning all of the equipment on virtual matrix space, i.e., by mapping, the input and output terminals
of each equipment shall have the virtual addresses. When this setting is complete, all of the equipment
that have crosspoints and constitute the system are assigned on the virtual matrix space. Generation of the
tallies are managed and handled by the virtual numbers that are assigned by this setting.
n
For router setup, refer to the System Setup Manual of the router.
This setup is used by the interface (on the S-Bus protocol) of switcher with router. However, because the
virtual numbers are required to be set in the tally system of even the systems that are not connected to S-
Bus/router, this setting must be implemented.
Menu screen
3-12
MVS-8000 System
SYSTEM SETUP