Inhibiting Dme Channel Selection Operations; Inhibiting Operation On The Key Control Block; Cross-Point Settings; Creating Cross-Point Assign Tables - Sony XVS-9000 User Manual

Multi format switcher system
Hide thumbs Also See for XVS-9000:
Table of Contents

Advertisement

2
Press [M/E Operation Inhibit].
The M/E Operation Inhibit menu (7321.18) appears.
3
Select the target bank to set.
4
In the <M/E Operation Inhibit> group, select the utility
2 bus (Util2 Bus) or key button (Key1 to Key8) for
which operations are to be inhibited.
Inhibiting DME Channel Selection
Operations
You can inhibit DME channel selection operations in the
device control block (trackball).
1
In the Engineering Setup >Panel >Config menu
(7321), press [Operation Inhibit].
The Operation Inhibit menu (7321.26) appears.
2
Press [Trackball Module].
The Trackball Module menu (7321.27) appears.
3
Select the DME channel for which to inhibit operation.
4
Press [Inhibit].
Inhibiting Operation on the Key
Control Block
You can set to inhibit operations for each module in the
key control block.
1
In the Engineering Setup >Panel >Config menu
(7321), press [Operation Inhibit].
The Operation Inhibit menu (7321.26) appears.
2
In the <Key Control Module Inhibit> group, select the
target module to set (1st to 4th).
To select a button/indicator/display state when
operation is inhibited
In the <Key Control Module Status> group, select one of
the following.
Enable: Buttons/indicators turn on and displays appear
according to the current setting status.
Disable: Buttons/indicators turn off and displays do not
appear.
Note
The button/indicator/display status settings are common to
all modules.

Cross-Point Settings

Creating Cross-Point Assign Tables

You can create a "main" table and up to 14 other tables
(table 1 to table 14) as cross-point assign tables. However,
you can only carry out assignment of video and key
combinations in the main table.
Creating the main table
In the main table, a pair consisting of a video signal and a
key signal is assigned to each button number. You can also
assign the same signal to another button number to
duplicate the assignment. You can also delete currently
assigned signals.
Note
The video/key pair numbers are fixed for the following
button numbers in tables 1 to 14.
Button number
281 to 286
291 to 296
The re-entry video/key numbers are set as the pair numbers
by default. Use the defaults as-is, since changing the
settings will make it impossible to select the correct
signals.
1
In the Engineering Setup >Panel >Xpt Assign menu
(7322) or the Engineering Setup >Panel >Xpt Assign
>Table Button Assign menu (7322.1), press [Main, V/
K Pair Assign].
The Main, V/K Pair Assign menu (7322.5) appears.
The left side of the status area shows the video and key
signal names currently assigned in the main table, and
the source numbers. When the shift button is pressed,
the number field is distinguished by color.
The right side of the status area shows a list of source
numbers and assignable signals.
2
Select the target button number to set.
No.
Parameter Adjustment
1
V/K Pair No Selection of video and key pair
3
In the <Assign> group, select the target signal to set.
Video: Set video signals.
Key: Set key signals.
405
V/K pair number
211, 221, 231, 241, 251, 261
216, 226, 236, 246, 256, 266
number

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents