This outputs a trigger from the selected output port. This is not output when the
trigger type is "Status."
Enabling or Disabling AUX Bus Control
1
2
3
4
5
Setting the Interface Between the DME and the Switcher
This system has a built-in DME that can be used for the dedicated interface, but
if also using an MVE-8000A or MVE-9000 as an external DME, it is necessary
to make the settings for interfacing to the switcher.
When using the MKS-6470, no settings are necessary.
166
Interfacing With External Devices (Device Interface Menu)
In the Switcher >Device Interface menu, press [Aux Control].
The Aux Control menu appears.
Select the 9-pin port for the setting, from the <Control> group.
Remote1: Make the settings for the REMOTE1 port.
Remote2: Make the settings for the REMOTE2 port.
Using any of the following methods, select the AUX bus.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
Knob
Parameter
Adjustment
1
No
AUX bus selection
a) 0: EDIT PVW
1 to 48: AUX1 to AUX48
Select whether to enable or disable AUX bus control from the <Control
Mode> group.
Enable: enable control of the port selected in step 2.
Disable: disable control of the port selected in step 2.
Manual: make whether control of the port selected in step 2 is possible or
not depend on the setting in the Misc menu.
Repeat steps 2 to 4 as required to make the settings for other ports.
Setting values
a)
0 to 48