The selected categories become candidates for
locking. The category name display color changes to
yellow, and the "Lock" indicator is displayed in
yellow in the "Lock" field.
To deselect a lock candidate
Select a lock candidate category, and press [Lock].
4
Repeat steps 2 and 3 to select all lock candidates.
To deselect all lock candidates
Press [Clear].
5
Press [Execute].
6
Enter a password of up to 16 characters in the
keyboard window, and press [Enter].
The categories in the list of candidates are all locked.
The category name and the "Lock" indicator in the
"Lock" field change to white.
To release the lock
Select a locked category and press [Lock], then press
[Execute] and enter the password.
Changing the lock password
1
In the Engineering Setup >System >Maintenance
>File Load Lock menu (7317.2), press [Change
Password].
2
Check the message, then press [Yes].
3
Follow the on-screen instructions to enter the old
password and new password.
Enabling/Disabling SDI Output
Connectors
The signal output from the output connectors of the
XKS-S8167/XKS-S9167 12G-SDI Output Boards can be
enabled/disabled.
When disabled, no signal is output from the output
connector.
Note
To prevent radio wave interference from occurring,
disable output connectors that do not have a cable
connected.
1
In the Engineering Setup >System >Maintenance
menu (7317), press [SDI Output Enable].
The SDI Output Enable menu (7317.3) appears.
2
In the <Device> group, select the target switcher to set.
The status area shows the set status of the output
connectors for slots in which an XKS-S8167/
XKS-S9167 is installed.
3
In the status area, select the target output connector to
set.
4
In the <Output> group, select whether to enable or
disable the output.
Enable: Enable signal output.
Disable: Disable signal output.
To enable all output connectors
Press [All Enable].
To clear the setting
Press [Clear].
5
Press [Execute].
6
Check the message, then press [Yes].
398