Locking File Loading Operations; Enabling/Disabling Sdi Output Connectors - Sony XKS-C9111 User Manual

Lock Item Select button
[Lock Item Select] turns red, and a padlock icon appears.
The lock candidate menu selection is reflected in the
Engineering Setup >System >Maintenance >Setup
Operation Lock menu (7317.1).
Note
If a menu is already locked, selection of lock candidates is
not possible. In this case, [Lock Item Select] is displayed
as follows.
When the displayed menu is
locked
In the Setup Operation Lock menu (7317.1), unlock the
menu and then select a lock candidate.

Locking File Loading Operations

You can inhibit load operations for a specified file
category.
1
In the Engineering Setup >System >Maintenance
menu (7317), press [File Load Lock].
The File Load Lock menu (7317.2) appears.
2
Select the category as the candidate for locking.
To select all categories, press [ALL].
3
Press [Lock].
When a menu other than the
displayed menu is locked
405
The selected categories become candidates for
locking. The category name display color changes to
yellow, and the "Lock" indicator is displayed in
yellow in the "Lock" field.
To deselect a lock candidate
Select a lock candidate category, and press [Lock].
4
Repeat steps 2 and 3 to select all lock candidates.
To deselect all lock candidates
Press [Clear].
5
Press [Execute].
6
Enter a password of up to 16 characters in the
keyboard window, and press [Enter].
The categories in the list of candidates are all locked.
The category name and the "Lock" indicator in the
"Lock" field change to white.
To release the lock
Select a locked category and press [Lock], then press
[Execute] and enter the password.
Changing the lock password
1
In the Engineering Setup >System >Maintenance
>File Load Lock menu (7317.2), press [Change
Password].
2
Check the message, then press [Yes].
3
Follow the on-screen instructions to enter the old
password and new password.
Enabling/Disabling SDI Output
Connectors
The signal output from the output connectors of the
XKS-S8167/XKS-S9167 12G-SDI Output Boards can be
enabled/disabled.
When disabled, no signal is output from the output
connector.
Note
To prevent radio wave interference from occurring,
disable output connectors that do not have a cable
connected.
1
In the Engineering Setup >System >Maintenance
menu (7317), press [SDI Output Enable].
The SDI Output Enable menu (7317.3) appears.