Table of Contents
Advertisement
A confirmation message appears.
3
Select [Yes].
Switching between button number mode
and pair number mode
When assigning a macro attachment to a cross-point
button, you can select the mode as either by button number
or by pair number (video and key).
Notes
If you change the mode using the following procedure, all
macro attachment data relating to cross-point buttons is
lost.
1
In the Macro menu, select VF2 'Attachment.'
The Attachment menu appears.
2
In the <Xpt Attachment Mode> group, select one of
the following.
Button Mode: Button number mode. Assign an
attachment combination of bus and button
numbers.
Pair Mode: Pair number mode. Assign an attachment
combination of bus and pair numbers.
A confirmation message appears.
3
To confirm changing the mode, select [Yes]. To
cancel, select [No].
Notes
• In pair number mode, carry out operations as follows.
- When a single pair number is assigned to multiple
cross-point buttons, pressing any of them executes the
macros of all cross-point buttons to which the same
pair number is assigned. Further, if you delete any of
these assignments, this deletes all assignments to the
same pair number.
- If you assign a pair number to a different cross-point
button, the attachment settings are also transferred to
the new cross-point button.
• When macro attachment data is loaded to overwrite
existing data, this also changes the button number mode
or pair number mode setting.
Displaying the Macro Attachment
List
In the Macro >Attachment menu, you can display the
macro attachment list to check the macro attachment
settings.
520
Macro Attachment Assigning
The macro attachment list includes the following columns.
• Block: Shows the names of control panel blocks.
• Button: Shows the names of macro attachment assigned
buttons (of up to 30 characters).
• Reg: Shows the names of assigned registers.
• Name: Shows the names of macro registers.
• Mode: Shows the names of macro modes (Pre/Post/
1)
Only/---
).
Above the list is shown the names of the block and macro
attachment assigned button currently selected in the list.
1) When no macro mode is set
For details of the macro modes, see "Setting a macro
attachment to a button" (page 516).
For details of the macro attachment list display, see
"About the Macro Attachment List Display" (page 673) in
Appendix.
Moving quickly within the macro
attachment list from one block to another
When you are viewing the macro attachment settings for a
block in the macro attachment list, you can move quickly
from the current block to another block to check the
settings for that block by pressing the following buttons in
the <Block Select> group.
• P/P: Move to a block in the PGM/PST bank.
• M/E-1: Move to a block in the M/E-1 bank.
• M/E-2: Move to a block in the M/E-2 bank.
• M/E-3: Move to a block in the M/E-3 bank.
• M/E-4: Move to a block in the M/E-4 bank.
• M/E-5: Move to a block in the M/E-5 bank.
• Aux: Move to a section in the auxiliary bus control
block.
• Others: Move to a block/section in a location other than
the PGM/PST bank, M/E-1 to M/E-5 banks, and the
auxiliary bus control block.
Scrolling the list
To scroll the macro attachment list, do one of the
following.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
Knob Parameter Adjustment
1
No
Macro attachment
settings scrolling
Setting values
1 to maximum
value
Advertisement
Table of Contents
