Vtr/Disk Recorder Status Display; Cueup & Play - Sony MLS-X1 User Manual

Still image
Low speed
Reverse
direction
Maximum speed
To record
You can record to a VTR or a disk recorder (video disk
communications protocol).
Press and hold the [REC] button and press the [PLAY]
button to start recording.
During recording, the [REC] button is lit red.
To stop recording, press the [STOP] button or the [ALL
STOP] button.
Notes
• Recording is not possible when using the Odetics
protocol or AMP protocol.
• The following limitations apply for a disk recorder
(video disk communications protocol).
– Set the disk recorder type to [Recorder].
– The maximum length of time that can be recorded in
one operation is 30 minutes.
– Create a new file for recording.
– When resuming after interrupting recording,
recording to a file continues from the interruption
point. To record to a file other than the selected file,
unload the file and create a new file.
Device control block display
In the device control block of the ICP-X7000, the display
shows the following information.
• FILE: Recalled file name (for disk recorder)
• CRNT: Current timecode (hour:minute:second:frame)
• START: Start point timecode
(hour:minute:second:frame)
• STOP: Stop point timecode
(hour:minute:second:frame)
Note
The file name is displayed left-justified in ASCII
characters only (up to 20 characters).

VTR/Disk Recorder Status Display

Open the following menus.
• Home > External Device > Device > Cueup & Play
menu (16101.31)
• Home > External Device > Device > Timeline > Action
menu (16101.41)
Low speed
Forward
direction
Maximum speed
219
• Home > External Device > Device > Timeline >
Rewind Action menu (16101.42)
Information for the assigned VTR/disk recorder is
displayed for each channel selection button.
You can check the current timecode in [Current TC].
You can check the current VTR/disk recorder status in
[Status].
Status VTR
XXXX Communication with
device is normal, but
status information
cannot be acquired.
Local The REMOTE/LOCAL
switch of the device is
set to LOCAL.
Tape Out No tape is loaded.
Rec Recording
Cue> Cueing up in the
normal direction
Cue< Cueing up in the
reverse direction
Eject Ejecting cassette
Stb Off Stopped in standby off
mode
Stop Stopped in standby on
mode
Play Playing
FF Fast forwarding
Rewind Rewinding
Shtl> Playing in the normal
direction in shuttle
mode
Shtl< Playing in the reverse
direction in shuttle
mode
Var> Playing in the normal
direction in variable
mode
Var< Playing in the reverse
direction in variable
mode
Jog> Playing in the normal
direction in jog mode
Jog< Playing in the reverse
direction in jog mode
Still Playing still image
a) Not supported for the Odetics protocol and AMP protocol.
Cueup & Play
You can save cueup & play settings, such as start point/
stop point timecodes, in an effect timeline register and
then recall the settings as required.
Disk recorder
Cannot communicate
with device, or
communicating but
cannot read the
device type.
Port is not open.
a)
No file loaded.
a)
Recording
–
–
–
–
Stopped
Playing
–
–
–
–
Playing in the normal
direction in variable
mode
Playing in the reverse
direction in variable
mode
Playing in the normal
direction in jog mode
Playing in the reverse
direction in jog mode
–