ABB IRB 6620 Product Manual page 257

2
3
4
5
6
7
8
9
10
11
12
Refitting, motor axis 4
The procedure below details how to refit motor, axis 4.
1
Product manual - IRB 6620
3HAC027151-001 Revision: W
Action
Move the robot to a position where the upper
arm is pointed straight up.
This position enables the motor to be re-
placed without draining the gear oil, which
in turn saves time.
Any other position of the upper arm requires
a draining of oil from the gearbox for axis 4.
DANGER
Turn off all:
• electric power supply to the robot
• hydraulic pressure supply to the robot
• air pressure supply to the robot
Before entering the robot working area.
Remove the cable gland cover at the cable
exit of the motor by unscrewing its two at-
tachment screws.
Remove the cover on top of the motor by
unscrewing its four attachment screws.
Disconnect all connectors beneath the motor
cover.
In order to release the brake, connect the
24 VDC power supply.
Unscrew the motors four attachment screws
and plain washers.
Fit the two guide pins in two of the motor
attachment screw holes.
If required, press the motor out of position
by fitting removal tool, motor to the motor
attachment screw holes.
Lift the motor to get the pinion away from
the gear and disconnect the brake release
voltage.
Remove the motor by gently lifting it straight
out.
Action
DANGER
Turn off all:
• electric power supply to the robot
• hydraulic pressure supply to the robot
• air pressure supply to the robot
Before entering the robot working area.
© Copyright 2006-2020 ABB. All rights reserved.
4.6.4 Replacement of motor, axis 4
Note
Draining of oil is described in section
Draining, oil on page 156.
Shown in the figure Location of motor on
page 255.
Make sure the gasket is not damaged!
Connect to connector R2.MP4
• +: pin 2
• -: pin 5
Shown in the figure Location of motor on
page 255.
Art. no. is specified in Required equipment
on page 255.
Always use the removal tools in pairs!
Make sure the motor pinion is not dam-
aged!
Note
Continues on next page
4 Repair
Continued
257