Loop Detection Configuration; Detecting And Blocking The Loop Settings - Panasonic GA-ML Series Manual

5.4 Loop Detection Configuration 5.4.1 Detecting and Blocking the Loop Settings
5.4

Loop Detection Configuration

5.4.1
Use the following window to implement the settings on detecting and
blocking loops and display its settings.
Choose L2 Features > Detecting and Blocking Loops > Detecting and
Blocking Loops Settings to display the following window.
In the section of Detecting and Blocking the Loop Settings, you can
configure the following parameters.
Global State
From Port/ To Port
State
Mode

Detecting and Blocking the Loop Settings

Figure 5-38 Loop Detection Configuration
Parameter
This parameter enables or disables to set a function of
detecting and blocking a loop.
Choose the port you use.
This parameter enables or disables a function of a line
loop-back of the port specified.
Choose the mode of detecting and blocking a loop to
use on the port specified. The options available are as
follows.
• Shutdown - First, set a port to the shutdown
• Block - This allows you to set a port to the blocking
Overview
condition when a loop occurs. Then set it to the
blocking state.
state when a loop occurs.
5 L2 Features
126