3.2.15. Loop Detection Config
Select "Advanced Config" and "Loop Detection" and then "Loop Detection Config"
to open the screen shown in Figure 3-40. On this screen, you can configure the
Loop detection and blocking function settings.
Screen Description
Global Loop Detec-
tion Status
Target Port Select-
ing
Port Number
Link
Status
Figure 3-40 Loop Detection Config
Displays the status of the Loop detection and blocking function.
Enable
Enables the Loop detection and blocking function.
Disable
Disables the Loop detection and blocking function.
Select multiple target ports for configuring settings at a time.
Click the "Select All" button, and all ports will be selected.
Click the "Reset" button, and all ports will be deselected.
Click the "Set selected port (s) " button after selecting and changing the items
for configuring settings at a time, and the same settings will apply to the
selected ports.
Displays the port number.
Displays the link status.
Up
The link has been established successfully.
Down
The link has not been established.
Displays the status of the Loop detection and blocking function for that port.
Forwarding
Sending packets normally.
Loop Detect
Detecting a loop and blocking a port.
67