Configuration Recovery From Ftp Servers - Panasonic GA-ML Series Manual

14.2.2.3 Configuration Recovery from FTP Servers

Use the following window to recover the configuration of a switch from
an FTP server.
Choose Tool > Configuration Recovery ＆ Backup > Configuration
Recovery from an FTP Server on the tool-bar to display the following
window.
Figure 14-12 Configuration Recovery from the FTP Server
You can configure the following parameters.
Parameter
FTP Server IP
TCP Port (1-65535)
Username
Password
Source File
Destination File
Replace
Click Restore to start restoring.
14.2.2.3 Configuration Recovery from FTP Servers
Enter an IP address of an FTP server.
Enter the TCP port of the FTP connection.
Enter the username of the FTP connection. The number
of characters for the name can be up to 32.
Enter the password of the FTP connection. The number
of characters for the name can be up to 15.
Enter the path and name of a source file of a
configuration file existing in an FTP server. The number
of characters for this field can be up to 64.
Enter the destination path and its location on the switch
where a configuration file is saved. The number of
characters for this field can be up to 64.
• If you choose the running-config option, the
configuration file, which is in progress of being
executed by a switch, is recovered and overwritten.
• If you choose startup-config option, the start-up
configuration file on a switch is recovered and
overwritten.
If you choose this option, a configuration file on a
switch is replaced using the file.
Overview
14 Tool Bar
416