4.9. Line Configuration
Configure the settings related to loop detection function and the power
saving mode in "Interface configuration mode."
4.9.1. Loop Detection Configuration
Enable or disable the loop detection function and configure the
auto-recovery in "Interface configuration mode." Confirm the loop history by
executing the "show line loopback history" command in "Privileged mode."
Command to show the loop history
M24eG#
Command to delete the loop history
M24eG#
Command to enable the loop detection function
M24eG(config-if)#
Command to disable the loop detection function
M24eG(config-if)#
Command to configure the loop detection mode
M24eG(config-if)#
Command to enable the auto-recovery function
M24eG(config-if)#
Command to disable the auto-recovery function
M24eG(config-if)#
show line loopback history [tail <line>]
line loopback history clear
line loopback
no line loopback
line loopback mode <block l shutdown>
line loopback shutdown <sec>
no line loopback shutdown
364