Arp Inspection Log - Panasonic GA-ML Series Manual

9.7.1.2.5

ARP Inspection Log

Use the following window to display and clear the information on dynamic
ARP inspection log. In addition, you can configure the log-buffer value in
the window.
Choose Security > SAVI > IPv4 > Dynamic ARP Inspection > ARP
Inspection Log to display the following window.
In the section of ARP Inspection Log, you can configure the following
parameter.
Parameter
Log Buffer
Click Apply to reflect the change.
Click Clear Log to clear the ARP inspection log.
If two or more pages exist, enter the page numbers. Then click Go to
move to a specific page.
Figure 9-51 ARP Inspection Log
Enter the log-buffer size (value). The range is from 1 to
1,024. By default, the value is set to 32. When you
choose Default, use the default value.
9.7.1.2.5 ARP Inspection Log
Overview
9 Security
341