Gvrp Port - Panasonic GA-ML Series Manual

5.2.3.2

GVRP Port

Use the following window to implement the settings on GVRP Port and
display its settings.
Choose L2 Features > VLAN > GVRP > GVRP Port to display the
following window.
In the section of GVRP Port, you can configure the following parameters.
Parameter
From Port/ To Port
GVRP State
Join Time
Leave Time
Leave All Time
Click Apply to reflect the change.
Figure 5-13 GVRP Port
Choose the port you use.
This parameter enables or disables the GVRP port state.
Doing so allows a port to become a VLAN member,
dynamically. By default, this option is disabled.
Enter the value of a join-time. The range is from 10 to
10,000 (centiseconds). By default, the value is set to 20
centiseconds.
Enter the value for leave time; the range is from 10 to
10,000 centi-seconds. Enter the value of leave time. The
range is from10 to 10,000 (centiseconds). By default,
the value is set to 60 centiseconds.
Enter the value for Leave All time. The range is from 10
to 10,000 (centiseconds). By default, the value is set to
1,000 (centiseconds).
5 L2 Features
5.2.3.2 GVRP Port
Overview
95