Panasonic GA-ML Series Manual page 221

Parameter
Violate Action
Color Aware
Click Apply to add a new entry.
Click Delete to delete the entry specified.
If two or more pages exist, enter the page numbers. Then click Go to
move to a specific page.
Choose the violate action. The action specifies the
action you take on the packets, which violate the
normal and maximum burst size for a singe rate
policing. It specifies the action you take on the packets,
which conform to neither CIR nor PIR.
• Regarding a single rate policer, if the violate action is
not specified, a single-rate two-color policer is created.
• Regarding a two-rate policer, if the violation action is
not specified, the default action becomes the exceed
action.
The options available are as follows.
• Drop- This option allows you to drop the packets.
• Set-DSCP-Transmit - This option allows you to
configure and transmit the value of new DSCP to
packets. Enter the DSCP value in the entry field
displayed.
• Set-1P-Transmit - This option allows you to
configure and transmit the value of new IEEE 802.1p
to packets. Enter the IEEE 802.1p value in the entry
field displayed.
• Transmission - This option allows you to transmit
packets without switching them.
• DSCP-1P Configuration - This option allows you to
configure the values of DSCP and IEEE 802.1p in
packets to transmit them.
• Enter the values of DSCP and IEEE 802.1p in the
entry field displayed.
This parameter enables or disables a function of the
color aware.
• If the color aware is Enabled, a policer operates with
the color aware mode.
• If the color aware is Disabled, the policer operates
with the color blind mode.
7 QoS (Quality of Service)
7.2.7 Aggregate Policer
Overview
219