Panasonic GA-ML Series Manual page 106

In the section of VLAN Interface Settings, you can configure the
following parameters.
Parameter
VLAN Mode
Acceptable Frames
ing Ingress
Check
Native VLAN
VID
Action
VLAN Range Allowed Enter the VLAN range allowed.
Clone
From Port/ To Port
Click Apply to reflect the change.
Click Back to return to the previous window.
Choose Promiscuous from VLAN Mode to display the following window.
Figure 5-24 VLAN Interface (Edit and Promiscuous)
In the section of VLAN Interface Settings, you can configure the
following parameters.
Parameter
VLAN Mode
Choose the option of VLAN mode. The options available
are Access, Hybrid, Trunk, Promiscuous and Host.
Choose an operating option for acceptable frames.
The options available are Tagged only, Untagged
only and Admit All.
This parameter becomes available if you choose Trunk
from VLAN Mode. This action enables or disables a
function of checking Ingress.
If you set this option to on, the native VLAN function
becomes enabled. In addition, choose Untagged or
Tagged as the frame to support on this VLAN.
This parameter will be available if the Native VLAN
option is set to on. Enter the VLAN ID you use. The
range is from 1 to 4,094.
Choose the action you perform. The options available
are Nothing, All, Add, Delete, Except and Replace.
If you choose this option, you need to enable the clone
function.
Choose the port you use.
Choose an option of VLAN mode. The options available
are Access, Hybrid, Trunk, Promiscuous and Host.
5 L2 Features
5.2.6 VLAN Interface
Overview
Overview
104