2-Step Authentication Settings - Panasonic GA-ML Series Manual

9.4.3

2-Step Authentication Settings

Use the following window to implement the settings on the 2 step
authentication of the port specified and display its settings.
Choose Security > Authentication > 2-Step Authentication Settings to
display the following window.
In the section of 2-Step Authentication Settings, you can configure the
following parameters.
Parameter
2 Step Authentication
Timeout
From Port/ To Port
2 Step Authentication
Mode
Click Apply to check the content changed.
Click Clear to clear the information based on the condition specified.
Figure 9-30 2-Step Authentication Settings
Enter the time-out value. If this time passes, the second
step of an authentication is tried (or attempted). The
range is from 0 to 65,535 (minutes).
Choose the port you use.
Choose the 2 step authentication mode. The options
available are as follows.
• MAC-Web - Both MAC and WEB authentication are
used in the first step of the two-step authentication
method.
• MAC-Dot1X - Both MAC and IEEE802.11X
authentication are used in the first step of the two-
step authentication method.
• Dot1X-Web - Both IEEE 802.1X and WEB
authentication are used in the first step of the two-
step authentication method.
9.4.3 2-Step Authentication Settings
Overview
9 Security
316