Lldp Dot3 Tlv Settings - Panasonic GA-ML Series Manual

5.8.6

LLDP Dot3 TLV Settings

Use the following window to implement the settings on IEEE 802.3 LLDP
TLV and display its settings.
Choose L2 Features > LLDP > LLDP Dot3 TLV Settings to display the
following window.
In the section of LLDP Dot3 TLV Settings, you can configure the
following parameters.
Parameter
From Port/ To Port
MAC/PHY Config./
State
Link Aggregation
Maximum Frame Size This parameter enables or disables to transmit the
Click Apply to reflect the change.
Figure 5-66 LLDP Dot3 TLV Settings
Choose the port you use.
This parameter enables or disables to transmit the
MAC/PHY config./state TLV.
This parameter enables or disables to transmit the link
aggregation TLV.
maximum frame-size TLV.
5 L2 Features
5.8.6 LLDP Dot3 TLV Settings
Overview
169