13
sFlow
13.1
sFlow
13.1.1
Use the following window to display the definition of a sFlow collector.
Click sFlow to display the following window.
You can configure the following parameters.
Collector IP Status
Collector IP
Collector UDP Port
Sampler Rate Status
Sampler Rate
sFlow Settings
Figure 13-1 sFlow Settings
Parameter
This parameter displays if the host IPv4 address (which
is used as the sFlow collector) is valid or invalid.
This parameter displays the host IPv4 address, which is
used as the sFlow collector.
This parameter displays the port-number of sFlow
messages. If not specified, the port-number is set to
6,343
to 65,535.
This parameter displays if the settings on the sampler
rate is enabled or disabled.
This parameter displays the frequency of performing a
sampling: the number of frames needed for the sFlow
sampler rate. The sFlow sampler rate is calculated by 1/
rate. The range is from 1,024 to 65,536.
9 OAM(Operations, Administration & Management)
13.1 sFlow 13.1.1 sFlow Settings
Overview
,
as the default configuration. The range is from 1
403