Subnet Vlan - Panasonic GA-ML Series Manual

5.2.7

Subnet VLAN

Use the following window to implement the settings on a subnet VLAN
and display its settings. Configure the subnet VLAN. If you receive
untagged IP packets or priority tag IP packets through a port, both of
them are cross-checked (along) with the subnet VLAN entry by using the
source IP address. If the source IP is included in the entry subnet, the
packets are grouped (or classified) into the VLAN, which is defined on the
subnet.
Choose L2 Features > VLAN > Subnet VLAN to display the following
window.
In the section of the Subnet VLAN, you can configure the following
parameters.
Parameter
IPv4 Network Prefix /
Prefix Length
IPv6 Network Prefix /
Prefix Length
VID
Priority
Click Apply to add new entries based on the information specified.
Click Delete to delete the entry.
If two or more pages exist, enter the page numbers. Then click Go to
move to a specific page.
Figure 5-26 Subnet VLAN
Choose and enter the value of an IPv4 address of the
subnet VLAN and its prefix-length.
Choose and enter the value of an IPv6 address of the
subnet VLAN and its prefix length.
Enter a subnet VLAN ID to use. The range is from 1 to
4,094.
Choose the priority value to use. You can specify the
value within the range from 0 to 7. The lower the value,
the higher its priority will be.
5 L2 Features
5.2.7 Subnet VLAN
Overview
106