Aggregate Policer - Panasonic GA-ML Series Manual

7.2.7

Aggregate Policer

Use the following window to implement the settings on the aggregate
policer and display its settings.
Choose QoS > Advanced Settings > Aggregate Policer to display the
following window.
Figure 7-14 Aggregate Policer (Single Rate Settings)
In the section of the Single Rate Settings, you can configure the
following parameters.
Parameter
Aggregate Policer
Name
Average Rate
Normal Burst Size
Maximum Burst Size
Enter the name of the aggregate policer.
Enter the value of the average rate. The range is from 0
to 10,000,000 (Kbps).
Enter the value of a normal burst size. The range is from
0 to 16,384 (Kbyte).
Enter the value of the maximum burst size. The range is
from 0 to 16,384 (Kbyte).
7 QoS (Quality of Service)
7.2.7 Aggregate Policer
Overview
214