Panasonic GA-ML Series Manual page 223

Click Delete to delete the entry specified.
If two or more pages exist, enter the page numbers. Then click Go to
move to a specific page.
Click Set Action to display the following window.
Figure 7-17 Policy Map (Action Settings)
In the section of Set Action, you can configure the following parameters.
Parameter
None
Specify
New Precedence
New DSCP
New CoS
New CoS Queue
If you choose this option, no action is taken.
If you choose this option, an action needs to be taken
based on a configuration.
Choose the value of the new precedence for packets.
The range is from 0 to 7. If you choose the IPv4 Only
option, the IPv4 precedence is marked. If you do not
choose it, the precedence for both IPv4 and IPv6 is
marked. In the case of IPv6 packets, the top (three-bits)
traffic class for the IPv6 header can be the precedence.
The precedence configuration does not affect the CoS
selection.
Choose the value of new DSCP for packets. The range is
from 0 to 63. If you choose IPv4 Only, the IPv4 DSCP is
marked. If you do not choose it, DSCP for both IPv4 and
IPv6 is marked. The DSCP configuration does not affect
on choosing a CoS queue.
Choose the value of new CoS for packets. The range is
from 0 to 7. The CoS configuration does not affect on
choosing a CoS queue.
Choose the value of a new CoS queue for packets.
Doing so overwrites the original CoS queue selection. If
the policy map is applied to the exit-flow of an interface,
the settings on the CoS queue does not become
enabled.
7 QoS (Quality of Service)
7.2.8 Policy Map
Overview
221