10.4.3
CFM Maintenance End Point
Use the following window to display the settings on CFM maintenance
end point (MEP).
Choose CFM > CFM Maintenance End Point to display the following
window.
In the section of CFM Maintenance End Point, you can configure the
following parameters.
Parameter
MEPID
Port
Level
MA Service
VLAN
Direction
MEP Type
CC Status
Click Apply to reflect the change.
10 OAM (Operations, Administration & Management)
Figure 10-15 CFM Maintenance End Point
This parameter displays an ID of MEP (Maintenance End
Point). The range is from 1 to 8191.
This parameter displays a port.
This parameter displays an MEP level. The range is from
0 to 7.
This parameter displays a service-name.
This parameter displays a VLAN.
This parameter displays an input direction of MEP
(inward and outward).
This parameter displays the MEP type (remote MEP/
Local MEP).
This parameter displays the status of CC (Continuity
Check).
10.4.3 CFM Maintenance End Point
Overview
385