Table of Contents
Advertisement
Release 7.0.0 3DB 19286 ACAA Issue 01
WebEML User Manual
Note: To provision an Ethernet Ring, it is recommended to Create Ring Topology and ERP
Instances on all ring nodes prior to enabling the ERP Instance. To provision additional
Ethernet ring nodes repeat steps
To enable an ERP Instance
1. From the ERP Instance area, select ERP instance to enable. See
2. Select ERP Enabled check box (checked).
3. Click Apply.
4. Perform
5. Verify Port and Protection Statuses around the ring.
To add a PDH Flow to an ERP Instance
1. To add a PDH Flow to an ERP Instance
2. Add PDH flows to ERP Instance using the following procedure:
To enable an ERP Instance
3
to enable ERP Instance on all Ring Nodes.
i. Verify East Port Current Status is Normal.
ii. Verify West Port Current Status is Normal.
iii. Verify RPL Owner/RPL Port status is Blocked.
iv. Verify all other East and West Port Forward Statuses are Unblocked.
v. Verify all Protection Statuses are Idle.
See
Figure 386
for the following steps:
a. Select ERP instance to add PDH flows.
b. Enter PHD flow VLAN IDs in Add VLANS text field.
c. Click >>.
d. VLAN IDs are added to the VLAN ID table.
e. Click Apply.
Provision Ethernet Ring Protection (ERP)
1
through
12
on each ring node.
on all Ring Nodes. Repeat steps
Figure
385.
1
through
573
Advertisement
Table of Contents
