Table of Contents
Advertisement
Release 7.0.0 3DB 19286 ACAA Issue 01
Administer L1/L2 radio and L2 Ethernet LAG
ports
Figure 172
Add Ethernet ports to Ethernet LAG
i
iii
iv
To remove Ethernet or radio ports from a LAG port
1. Using the LAG Configuration Tool Settings tab, remove Ethernet/Radio ports
318
vii
i. From the Configured LAGs pane, select LAG to add port.
ii. If LAG Type is provisioned L2 Radio, then from the Available Ports pane,
select Radio port type (MPT).
iii. From Available Ports pane, select port to add to LAG.
iv. Click >.
v. If Type is provisioned L2 Ethernet, then from the Added Ports pane, select
priority (0 or 65535).
Note: default priority value is 128.
vi. Repeat steps
i
through
vii. Click Apply.
from LAG port using the following procedure:
To remove L1 Radio port from LAG port, see
To remove L2 Radio port from LAG port, see
v
v
to add additional ports to the LAG.
Figure
Figure
WebEML User Manual
22901
173.
174.
Advertisement
Table of Contents
