Table of Contents
Advertisement
Release 7.0.0 3DB 19286 ACAA Issue 01
WebEML User Manual
2. Using the craft terminal, verify all radio ports, to be members of the L1 Radio
3. Create L1 Radio LAG port.
Note: For a detailed procedure to create L1 Radio LAG port, see
or L2 Ethernet LAG
4. Add Radio ports to L1 Radio LAG port.
Note: For a detailed procedure to add radio ports to an L1 Radio LAG port, see
Ethernet or radio ports to LAG
5. Provision WTR parameter.
Note: For a detailed procedure to provision WTR parameter, see
Restore (WTR)
6. Provision PPP RF Configuration.The Remote IP Address field shows the IP
LAG port, are not associated with the following:
a. Cross-Connection
b. VLAN
c. Port Segregation
d. PPP RF enabled on the radio channel
e. Synchronization reference
f. SSM
g. Pkt throughput booster enabled (except MPT-HL on EASv2)
h. MPT-HL radio connected to a Core card
i. MPT-HLC radio connected to a Core or P8ETH card
port.
value.
address of the remote connected NE.
Administer L1/L2 radio and L2 Ethernet LAG
port.
ports
To create an L1/L2 Radio
To add
To provision Wait-To-
309
Advertisement
Table of Contents
