Table of Contents
Advertisement
Release 7.0.0 3DB 19286 ACAA Issue 01
WebEML User Manual
Verify appropriate port segregation is provisioned to prevent message flooding. Port
segregation should be provisioned between parallel radio paths at both ends when
they exist on the NE. Port segregation should also be provisioned between the radio
port and other Ethernet and/or radio ports where connectivity is not desirable.
43.5 SDH to Ring:
Caution: In the protected Core configuration, entering SDH cross-connections while the
spare Core is Active may affect existing SDH cross-connections. To prevent this from
occurring, ONLY provision SDH cross-connections while the main Core card is Active.
Caution: When parallel radio paths exist between two MSS shelves, port segregation
should be provisioned between the parallel radio paths at both ends to prevent a loss of
traffic.
43.5.1 Prerequisites
Each SDH port and Ring port must be enabled on the respective SDH card and
Ethernet Ring Protection Configuration provisioning screens.
The Service Profile on all SDH card Settings screen must be set to SDH2SDH for
each SDH cross connect.
Each SDH line to be cross connected must have a unique Flow ID number assigned
to it on the respective SDH card Settings screen.
Verify appropriate port segregation is provisioned to prevent message flooding. Port
segregation should be provisioned between parallel radio paths at both ends when
they exist on the NE. Port segregation should also be provisioned between the radio
port and other Ethernet and/or radio ports where connectivity is not desirable.
For information about Ring cross-connections in a mixed fiber/microwave Ring, see
Provision cross connections in a mixed fiber/microwave
Provision cross connections
Ring.
351
Advertisement
Table of Contents
