Table of Contents
Advertisement
Release 7.0.0 3DB 19286 ACAA Issue 01
WebEML User Manual
2. Select Synchronization Source in the resource tree area.
3. Select the Settings tab in the resource detail area.
4. Select the Master radio button in the Role partition.
5. Select a Restoration mode radio button: Revertive or Not Revertive.
6. Select a Primary Source radio button: Free Run Local Oscillator, E1/DS1 Port,
7. Which primary source was selected?
8. In the Sync Ports partition, from the Sync In Port drop-down menu, select Sync
9. Select Secondary Source radio button: Free Run Local Oscillator, E1/DS1
10. Go to step 20.
Synchronization Settings tab displays. See
Sync-In Port, Eth Port, or STM-1/OC-3 Port.
Note: If an MSS-1 is in use, the E1/T1 option is displayed instead of E1/DS1.
a. If Sync-In Port, go to step 8.
b. If E1/DS1 Port, go to step 11.
c. If Eth Port, go to step 14.
d. If STM-1/OC3 Port, go to step 17.
e. If Free Run Local Oscillator, go to step 29.
In Port frequency: 1.024 MHz, 2.048 MHz, 5 MHz, or 10 MHz.
Note: If a Sync-In/Out SFP is in use, the Sync Ports area is labeled Sync In/Out
SFPs. The Sync In Port appears as NOT USED. The SFP is displayed as Sync
In Port #5, #6, #7, #8, depending on where the SFP is placed; see
Port, Eth Port, STM-1/OC-3 port, or None.
Administer synchronization
Figure
182.
Figure
186.
337
Advertisement
Table of Contents
