Table of Contents
Advertisement
Release 7.0.0 3DB 19286 ACAA Issue 01
Provision cross connections
Note: Ranging is supported for RADIO-RING cross-connection entry.
5. From the Service Profile drop-down menu, select TDM2TDM or TDM2ETH.
6. Is the Profile configured with TDM2ETH?
7. From the TDM Clock Source drop-down menu, select ADAPTIVE or
8. On the RADIO-RING pop-up, click >>.
9. Repeat steps
10. Click OK.
11. On the Cross Connection screen, click Apply.
12. From the Connections tab, verify the RADIO-RING cross-connections were
To provision an Ethernet to Ring Cross Connection
1. Verify port segregation provisioning. Port segregation should be provisioned
378
a. If yes, go to step 7.
b. If no, go to step 8.
DIFFERENTIAL.
4
through
connections on this ERP Instance.
entered correctly.
Caution: When parallel radio paths exist between two MSS shelves, port
segregation should be provisioned between the parallel radio paths at both ends
to prevent a loss of traffic.
between parallel radio paths at both ends when they exist on the NE. When
making a cross connection to one of parallel radio ports, port segregation should
also be provisioned between the Ethernet port and all other parallel radio ports.
Also port segregation should be provisioned between the Ethernet and radio
8
to provision additional Radio to Ring cross-
WebEML User Manual
Advertisement
Table of Contents
