Figure 275 Sdhchann Main View - Nokia 9500 MPR User Manual

Release 7.0.0 3DB 19286 ACAA Issue 01
WebEML User Manual
Figure 275 SDHCHANN main view
8. Provision the STM-1 port using the following procedure:
a. Put a check mark in the Port Status box to enable the STM-1.
b. Set the Auto Laser Shutdown: Enabled/Disabled ForcedOn/Disabled
ForcedOff. This field will appear only if the Settings tab-panel of the STM-1
unit the optical SFP has been selected.
c. Select the Clock Source.
d. Enable the J0, if required, by selecting one of the two modes
(SixteenBytesFrame/OneRepeatedByte) in the Expected Receiving
Value field and enter the expected value and in the Sending J0 field select
one of the two modes and enter the value to be transmitted. Note: byte J0
is only read, no Regeneration section Termination is done.
e. Click on Apply.
f. Enable, if required, the E1 Node Timing Configuration. The Node Timing
is the timing from the network clock as defined in G.8261. The enabling of
the Node Timing is applied to all E1s of the unit. By enabling the Node
Timing the E1 streams in Rx side are retimed at the output with the network
element clock.
Provision equipment port
457