Nokia 9500 MPR User Manual page 845

Release 7.0.0 3DB 19286 ACAA Issue 01
WebEML User Manual
56. Provision the MPT-HLS Synchronization Status Messaging
Note: If the MPT-HLS is part of a LAG, you cannot change the SSM or PPP settings on an
individual radio. Go to
ports.
57. Provision MPT-HLS radio channel Synchronization SSM:
58. Provision the MPT-HLS Point to Point Protocol settings
Note: If the MPT-HLS is part of a LAG, you cannot change the SSM or PPP settings on an
individual radio. Go to
ports.
Note: OSPF Area must be provisioned prior to provisioning the PPP RF channel.
59. Provision the PKT throughput booster setting
ii. Enter the Expected Identifier value (0 to 255).
iii. Enter the Sent Identifier value (0 to 255).
iv. Click Apply.
Administer L1/L2 radio and L2 Ethernet LAG ports
Open the appropriate radio main view depending on your radio configuration
and select the Additional Settings tab; see
i. Select the Synchronization SSM Enabled check box.
ii. Click Apply.
Administer L1/L2 radio and L2 Ethernet LAG ports
Open the appropriate radio main view depending on your radio configuration
and select the Additional Settings tab; see
Provision MPT-HLS radio channel PPP:
i. From the PPP RF panel, select the Enabled check box.
ii. Select the Routing IP Protocol: (OSPF or None).
iii. If OSPF is selected, then select OSPF Area: (0 to 4).
iv. Click Apply.
Configure radio parameters
to administer LAG
Figure 633.
to administer LAG
Figure 633.
845