Release 7.0.0 3DB 19286 ACAA Issue 01
WebEML User Manual
3.
Figure 682
SDHCHAN configuration screen
viii. Node Timing: timing from the network element clock as defined in G.8261.
The enabling of the Node Timing is applied to both the STM-1. By enabling
the Node Timing the SMT-1 streams in Rx side are retimed at the output
with the network element clock.
Figure 682
shows the configuration screen for SDHCHAN.
i. Select the Port type: SFP-O (Optical) or SFE-E (Electrical)
ii. Put a check mark in the Port Status box to enable the STM-1.
iii. Set the Auto Laser Shutdown: Enabled/Disabled ForcedOn/Disabled
ForcedOff. This field will appear only if the Settings tab-panel of the STM-1
unit the optical SFP has been selected.
iv. Select the Clock Source.
Use the Provisioning Tool
911