Table of Contents
Advertisement
Release 7.0.0 3DB 19286 ACAA Issue 01
Administer L1/L2 radio and L2 Ethernet LAG
ports
Note: For a detailed procedure to provision PPP RF Configuration, see
RF
7. Click Apply.
8. From the LAG Information pane, select the Enabled check box (checked).
9. Click Apply.
10. Provision SSM support.
Note: For a detailed procedure to provision SSM support, see
L1 radio LAG port
11. Provision packet throughput booster (PTB) if available.
Note: For a detailed procedure to provision PTB, see
and
12. Click Apply.
13. Verify L1 Radio LAG port provisioning.
To provision an L2 radio LAG port (not available with a CorEvo card)
1. Using the craft terminal, verify all radio ports, to be members of the L2 Radio
310
configuration.
and
To disable SSM support for L1 radio LAG
To disable PTB for L1 radio LAG
LAG port, are provisioned correctly. Correct any radio port provisioning that
does not correspond to the desired radio performance characteristics. Verify the
following parameters:
− Tx and Rx Frequency
− Shifter
− Synchronization SSM enabled/disabled
To enable SSM support for
To enable PTB for L1 radio LAG port
port.
WebEML User Manual
To administer PPP
port.
Advertisement
Table of Contents
