Table of Contents
Advertisement
Release 7.0.0 3DB 19286 ACAA Issue 01
Configure radio parameters
35. Provision the MPT-HL Point to Point Protocol settings
Note: OSPF Area must be provisioned prior to provisioning the PPP RF channel.
36. Provision the PKT throughput booster setting
37. Administer the MPT-HL Alarm Profile settings
To provision the MPT-HLC transceiver
1. Select an action.
802
i. From the PPP RF panel, select the Enabled check box; see
ii. Select the Routing IP Protocol radio button: (OSPF or None).
iii. If OSPF is selected, then select OSPF Area: (0 to 4).
iv. Click Apply.
See
Figure 603
for the following steps:
i. From the Pkt Throughput Booster panel, select the Enabled check box.
ii. Click Apply.
See
Figure 603
for the following steps:
a. In the Alarm Profile panel, click on the Alarm Severity Profile icon. The
Alarm Severity Profile window opens.
b. Choose an alarm severity profile. Click on the Show details button for more
information if needed.
c. Click Apply.
a. To
Configure the MPT-HLC co-channel
b. To
Configure the MPT-HLC 1+1
c. To
Configure the MPT-HLC radio protection
d. To
Provision the MPT-HLC radio for fixed
e. To
Provision the MPT-HLC radio for adaptive
f. To
Provision the MPT-HLC 1+1 spare radio
g. To
Provision the MPT-HLC manual transmit power level
step 38.
h. To
Provision the spare MPT-HLC
WebEML User Manual
XPIC, go to step 2.
XPIC, go to step 13.
type, go to step 24.
modulation, go to step 29.
modulation, go to step 32.
channel, go to step 35.
RTPC, go to step 41.
Figure
603.
(RTPC), go to
Advertisement
Table of Contents
