Nokia 9500 MPR User Manual page 321

Release 7.0.0 3DB 19286 ACAA Issue 01
WebEML User Manual
Figure 175 Remove Ethernet ports from LAG port
i
v
vi
Note: In Provider Bridge mode, a port removed from an L2 Ethernet LAG will be managed
as an NNI port.
viii
i. From the Configured LAGs pane, select LAG to remove ports.
ii. If last L1/L2 Radio LAG port and PPP RF is enabled, then from the PPP RF
pane, select the Enabled check box (unchecked).
iii. If last L1 Radio LAG port and SSM is enabled, then from the SSM pane,
select the Enabled check box (unchecked).
iv. If last L1 Radio LAG port and PTB is enabled, then from the PTB pane,
select the Enabled check box (unchecked).
v. From the Added Ports pane, select the Port to remove from LAG.
vi. Click <.
vii. Repeat this procedure to remove additional ports from the LAG.
viii. Click Apply.
Administer L1/L2 radio and L2 Ethernet LAG
ports
22909
321